First used the CAD software such as TAJIMA 7.0 or Wilker making lithograph plates, after producing the proof plate, put the USB which have the embroidery programme and patter into the computer disk driver , under the programmed control, the computer changes into the pattern coordinate figure with the frame X, Y direction displacement quantity suitable electrical signal, after delivering X, Y, Z monolithic system to carry on the motor rises to change down processing, the output three-phase six time signatures, after motor's power amplifier box carry on the power amplification, outputs for X, Y motor, leads the frame to complete during X, Y the reciprocal motion; Simultaneously actuates the Z motor, leads the needle to make the vertical motion, make the embroidery to work continuously. The Z motor through actuation nose transmission system revolving and so on synchronized tooth profile belt, head’s specific organization causes the lead wire organization and machine needle brings the facial suture to make the high and low reciprocal motion, the puncture lining; Turns on rotary hook to cancel the facial suture to by pass has the agent the bobbin case, forms locks the type line mark; Selects the line organization movement, transports and tightens the facial suture, the preparation next line mark facial suture line segment. Xth, the Y electrical machinery through organizations and so on synchronized tooth profile belt leads stretches the frame and the lining makes the plane motion. Each treats the lining on embroiders the line mark spot to escort to machine the needle embroidery, machine the needle vertical motion's speed with stretches the direction which, the travel motion as well as the traveling speed sychromesh movement the frame moves, causes the facial suture and the agent lay-up, makes the double thread on the lining to lock the type line mark. When the embroidery works continuously, completes the pattern embroidery.